Reasons Your Water Heater is Leaking
9/14/2020 (Permalink)
Flushing A Water Heater
Maintaining your Edmond, OK home's water heater can extend its life and help it work efficiently. One way to ensure it keeps running at peak performance is to flush it out. This process cleans away sediment that collects inside the water tank and can be performed in a few simple steps.
1. Cut the Power
It is vital to your safety that you turn off the power to your water tank before you perform the flush. Turn off the circuits to the room where you house your heater, or snuff out the pilot light. While the tank cools, you can collect a few tools you will need to complete the flush, including rubber gloves, a garden hose and a screwdriver.
2. Connect the Hose
Locate the drain valve on your water heater and connect one end of the hose there. Remember to wear the gloves. Set the other end of the hose into a large bucket or drainage ditch outside to collect the excess water and sediment. Once the hose is secure, turn the valve back on and allow the water to drain.
3. Perform the Flush Several Times
Once the water drains for a minute, go to the kitchen and run the hot water faucet for a few moments to help the tank empty. Then you can close the water supply valve again until the draining stops. You can perform the water heater flush several times. Remember to close valves on the heater before you turn the water supply back on, then run the faucet until it stops spitting air and runs smoothly before you restore the main power to the heater.
If something should go wrong and you still hear crackling or popping when you run your heater, call a water cleanup and restoration company to flush your tank professionally. If the sediment buildup is considerable, you may not be able to clear it on your own.
Maintaining your Edmond, OK home's water heater can boost its efficiency. Flushing your unit is one of the best ways to keep it operating for years of worry-free performance.